need help on analog values

hello all,
i am very new to analog values on PLCs.
write now m working on OMRON PLC - CJ1M.
my prob is i am not able to understand how to read analog values on PLC.
analog value is 0-10V.
Pls help me.

Hi,

I don't have experience about Omron, however take a look at this manual of the analog I/O cards.........

http://downloads.industrial.omron.i...s/W345/W345-E1-11+CS-CJ-Series+OperManual.pdf

it seems to explain well

hi cagliostro
but can i have some snapshot example for step by step learning.
I am using OMRON 8 analog input card CJ1W-AD081-V1.
My PLC configuration is CJ1M 12CPU with 2 Input card (16 input each) and 4 output cards (16 each) then this analog input card.
All my job is complete but this analog reading section is still pending.
I am very new on omron and analog values....
Help me....

You'll find some example, in the "Appendix B Sample Programs" of the user manual.

thnks sir
i feel now i can do it.
will revert u back about the results.
thanks

Go online with CX-Programmer - turn the PLC to program mode - set up an I/O table - drill into the analogue card and set it up with the software setup.