ML1100 with Modbus TCP

tlona

Member
T
Join Date
May 2007
Location
New Jersey
Posts
33
I have a AB ML1100 that I am using to collect data from a device sending data over Modbus TCP/IP. From what I understand I will have to use the serial channel on the ML1100 not the ethernet port. I assume then I will need something to convert the modbus TCP/IP back to serial. Does anyone know if the n1761-net-eni will do this or is there some other third party device I will need.
thank-you
 

Similar Topics

C
ML1100 as Modbus RTU Master
Hello all, I am trying to setup my MicroLogix 1100 as a modbus RTU master for a modbus network containing multiple modbus RTU slaves. I currently...
Replies
7
Views
3,927
Ken Roach
Ken Roach
L
modbus and ml1100 help.
Hello, i have a micromotion flow transmitter communicating with a ML1100 plc via modbus over channel 0. i am messaging to read data from the...
Replies
6
Views
2,448
OkiePC
OkiePC
T
ABB TotalFlow Modbus to ML1100 help!
So I have an ABB TotalFlow uFlo G4 unit and have configured it's COMM port as Modbus Slave. I have also mapped internal 32Bit Float Registers to...
Replies
9
Views
5,828
Nmill
N
A
ML1100 modbus
Hi all. I have some problems with ML1100 and modbus rtu, I have 2 nodes with solcon HRVs soft starter and MPS3000, ML has 1763-NC01, the ladder...
Replies
13
Views
5,449
avkiv14
A
C
Modbus communication for ML1100 and Honeywell dcs
I am using Micrologix1100 as Modbus slave and Honeywell dcs as Modbus mater. ML1100 communication parameters configured with the Channel0 are as...
Replies
9
Views
9,017
chandu_bagal
C
Back
Top Bottom