Manual tuning this instruction as with older pid's " set Kp until oscillates and half it then increase Ki until offset is correct to sufficient time and leaving Kd at zero" has not been to successful. The auto tune button works about as well as any other I have seen. Any info. on how to achieve this faster please do tell.
Pide instruction control logix
- Thread starter Britt
- Start date
rdrast
Lifetime Supporting Member
I haven't had any particular problem tuning PIDE's, (remember to hit "Apply" after EVERY change), but the PIDE instruction is much less reliable then the old standard PID instruction.
Do you absolutely need the (somewhat dubious) enhancements the PIDE instruction provides?
Do you absolutely need the (somewhat dubious) enhancements the PIDE instruction provides?
Similar Topics
Hello All,
Looking to get a better understanding behind an issue that I had earlier today with a PIDE Instruction that was not changing it's CV...
Hi:
I have a process where I need to control flow with a bomb with Powerflex700. I have a periodic PIDE instruction, Flowmeter is the PV and CV...
Hello,
I am running a PIDE instruction and its running OK but when i open the PIDE properties of the instruction, its status shows InstructFault...
Hi,
In one of our project, we are using PIDE Instruction block (FBD) for all closed loop controls operated through MMI. In that, when the...
I am working on a large migration of the standard PID instruction to the PlantPAx P_PIDE. Has anyone done a migration like this before and have a...