Output Module ALG391
- Thread starter jcp
- Start date
Yes, but you must follow instructions in the manual to make it work properly and it is less accurate in voltage mode than in current mode.
Details of this module are in this manual:
gfk0898f.pdf
Details of this module are in this manual:
gfk0898f.pdf
Last edited:
Similar Topics
Hi friends;
I use one channel of ALG391 Module for 4 to 20 mA. Can i used second channel for 0 to 5 Volt?
Regards
Preface:
Kinda long, so I made section titles
Intro:
I just want to see if anyone here has seen anything similar. A PLC5-40 series C enhanced...
I have run into a problem with my first time installing a 2080-OF2 module on a Micro820 and have a hunch that the module itself - brand new out of...
Hello,
I am trying to streamline an AOI that will get module/controller statuses from ethernet IO tree. Everythings fine, however, does anyone...
Hello everyone,
I am having issues with an output module connected to my 5069-L306ER PLC. The modules I have connected are a 5069-IA16 in slot 1...
