S7 300
- Thread starter Damilare
- Start date
ivo.maenen
Member
- Join Date
- Nov 2003
- Posts
- 663
I think you need to give more information.
Is the network: 1 plc - 1 slave?
Has the connector of the plc only one cable? If so: check if the cable goes into the correct entry-point.
Is the terminating resistor active of not?
Is the network: 1 plc - 1 slave?
Has the connector of the plc only one cable? If so: check if the cable goes into the correct entry-point.
Is the terminating resistor active of not?
Similar Topics
Hey all, first time poster here.
I am wondering if anyone has tried using a Keyence SR-X300 barcode scanner to a Micrologix 1400.
Keyence sent...
Hi Siemens guys!
I am experiencing SF fault on our S7-300 (6ES7 315-2AH14-0AB0) CPU from time to time. I've checked the diagnostic buffer and...
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...
Hello PLCS.Net Forum,
First time posting. Let's assume I am a novice.
BASIC PROBLEM:
My servo/linear piston is no longer zeroed to the...
hi...
i have an issue in s7 300 plc, while we run the machine(in idle there is no fault) , plc cpu goes in SF mode, after restart the power cycle...