albert_grigoriev
Member
Hi All
Bosch-Rexroth phases out DPQ and DPC cards.
Russian office of the company advised to consider HACD-3 or HCN100 cards to control 2 axes.
But these cards do not have an HMI for injection and clamp control as DPQ and DPC had.
Can somebody advise is it difficult to configure HACD-3 or HCN100 for IMM?
Bosch-Rexroth phases out DPQ and DPC cards.
Russian office of the company advised to consider HACD-3 or HCN100 cards to control 2 axes.
But these cards do not have an HMI for injection and clamp control as DPQ and DPC had.
Can somebody advise is it difficult to configure HACD-3 or HCN100 for IMM?