spence144db
Member
I am hear to call upon the vast knowledge of the community.
If you look at the program below you will see a sequence of timers that should all run and at the end of the sequence they SHOULD just stop. (I think) when the last timer in the line up is done the T4:1.TT in LAD2 R:0 will just activate itself with no human input??!!!?!? Can some one explain to me how this is possible.
Also if you look in LAD 3 I am in the process of trying to figure out how to make this whole process run 1 time with a switch off and run 2 times then stop with a switch on...i have been looking at this problem for about a day and my head hurts.
If you look at the program below you will see a sequence of timers that should all run and at the end of the sequence they SHOULD just stop. (I think) when the last timer in the line up is done the T4:1.TT in LAD2 R:0 will just activate itself with no human input??!!!?!? Can some one explain to me how this is possible.
Also if you look in LAD 3 I am in the process of trying to figure out how to make this whole process run 1 time with a switch off and run 2 times then stop with a switch on...i have been looking at this problem for about a day and my head hurts.