Mitsubishi Q series battery light

mechtec

Member

M

Join Date

Oct 2012

Location

Illinois

Posts

38

• Apr 10, 2013

• #1

Have a new machine installed with Q series PLC. Battery light was flashing so I pulled the battery which had not been connected. Connected battery, light continued to flash. Switched to stop and back to run and the light still flashes. Is there a procedure to put the light out?

Thanks,

 

Mr. Roboplc

Member

M

Join Date

May 2013

Location

olongapo

Posts

2

• May 21, 2013

• #2

have you tried connecting the black and red wire to the battery?

 

dantut

Member

D

Join Date

Mar 2010

Location

NJ

Posts

13

• May 21, 2013

• #3

There is not reset for the battery light. If it is plugged in then the light would go out. Here is link for Q quickstart guide.

https://www.koningenhartman.nl/UserFiles/Quick_Start_Up_SystemQ.pdf

 

mechtec

Member

OP

M

Join Date

Oct 2012

Location

Illinois

Posts

38

• May 21, 2013

• #4

Thanks guys. I did find in the Programming Manual that I need to run an LEDR instruction to reset the LED. I am not in the plant for a couple weeks but will try this when I get back.

 

dantut

Member

D

Join Date

Mar 2010

Location

NJ

Posts

13

• May 21, 2013

• #5

mechtec said:

Thanks guys. I did find in the Programming Manual that I need to run an LEDR instruction to reset the LED. I am not in the plant for a couple weeks but will try this when I get back.

Click to expand...

I learned something new about the Q today. Thanks Mectec. I will remember that LEDR command.