Will a Sigma V 400V drive power 200V servos? I have looked through the documentation and must have missed it - I have some 200V servos sitting on the shelf, but need to put 400V drives in the machine (480VAC supply).
TIA!
Chip
TIA!
Chip
Yaskawa Sigma V 400V Drive Power 200V Servo?
- Thread starter cstech
- Start date
Highland Controls
Member
No. Yaskawa drives only work with specific motors(usually a 1:1 relationship).
Similar Topics
Good Evening Everyone,
I have a servo question. With a master slave setup, one motor was going into overload. I found this pretty quickly as the...
This is a little OT but I'm looking for anyone with experience with the Yaskawa Sigma 5 servo drives. We've had some servo drive and motor...
Is there any way to configure a Yaskawa MP2300Siec controller to see an over travel switch directly wired to it, rather than through the Sigma 5...
Hello
I have a new Yaskawa Sigma 5 with Mp2600 controller. I am attempting to go online with the controller. I set the config and E-init dip...
Hi friends, anyone familiar with YASKAWA Sigma II motion controllers? I have an error reading A.03 Not getting too much from the manuals error...