This question is about PLC Schneider Momentum M1 171 CCC IEC-960-30.
We have one output element ADO 710 50 attached to the PLC via 170ENT11002. This element is in Concept Configurator mapped to a specific address (40203) for Write.
Setting for Read for this element is "Set to 0" (not "Keep last value") - but I suppose it is not used, since it is digital output element so PLC reads no bites from it.
When there is interruption of network communication between 170ENT11002 and Momentum PLC, does the state of the digital outputs in ADO 710 50 remains the same as it was during the last successful cycle or is it reset to 0?
(There was sudden stop of 2 (of 7) machines attached to the element, but I doubt it was caused by the PLC system)
We have one output element ADO 710 50 attached to the PLC via 170ENT11002. This element is in Concept Configurator mapped to a specific address (40203) for Write.
Setting for Read for this element is "Set to 0" (not "Keep last value") - but I suppose it is not used, since it is digital output element so PLC reads no bites from it.
When there is interruption of network communication between 170ENT11002 and Momentum PLC, does the state of the digital outputs in ADO 710 50 remains the same as it was during the last successful cycle or is it reset to 0?
(There was sudden stop of 2 (of 7) machines attached to the element, but I doubt it was caused by the PLC system)
