Diameter measurement by tacho generator
- Thread starter abu
- Start date
Steve Bailey
Lifetime Supporting Member + Moderator
A tach generator produces a voltage level proportional to its rotational speed. If there is a relationship between that and the diameter of the object you want measure, then it's possible.
You need to provide a little more detail.
You need to provide a little more detail.
Similar Topics
I have an application where I do unrolling of a bobbin.
It is a central unwinder (axis of the bobbin is driven).
We have no diameter measurement...
Good afternoon, I have an application where I need to measure the diameter on the end of a crankshaft. Need a PNP 24VDC 3-4 wire device using m12...
I pretty sure this has been covered before, but I need to ask. I have an Unwinding roll of paper and I want to display the diameter of the roll...
I was wondering if someone could help me with the geometry of a two drum surface winder. I am trying to calculate diameter of the roll using the...
I test about winder machine.I use linear velocity and winder shaft rpm calculate</SPAN> diameter.But I found when the linear about 5m/min,the...