RS485 update rate

DLMUK

Member
D
Join Date
Jun 2013
Location
Southampton
Posts
311
Hi,

I need to try and calculate an update rate for an RS485 network but I am not quite sure where to start.

I assume I would need to take into account the following:

baud rate
size of data being sent
Update rate of client
update rate of receiver

Does anybody have an experience of doing this?

Many thanks,
 

Similar Topics

K
RS485 Modbus RTU using PC com port in Twincat 3 issues
I'm trying to control a device via MODBUS RTU and the ModbusRtuMasterV2_PcCOM in Twincat 3. I've configured a device with the right com port and...
Replies
7
Views
257
Jkoso
J
R
Connecting Modicon 984 PLCs Using RS485
Hi, Seeking consultation on an implementation matter, and have a question about Modicon Compact 984 communication through RS485: Three Modicon...
Replies
4
Views
251
r6lpq8twg52
R
A
MIL 1553B to RS485/RS232 connectors/converters
i have an device which can support serial (RS485,RS232),CAN protocol . i want to connect it to an existing MIB 1553B bus ,what device will I need...
Replies
0
Views
105
AP000001
A
I
CB1241 RS485 Board LED's not lighting up with S7-1200 1215C
Hi all, I am trying to do Modbus communications via the CB1241 RS485 Communication Board on a Siemens S71200 PLC. I am using a 1215C CPU. After...
Replies
6
Views
278
tarik1978
T
N
Red Lion Graphite G12-RS485 port loses connection to Red Lion Cub
I'm trying to use a Red Lion Cub counter (Cub5B00) as a counter and give the cub's counts to a Graphite G12 PLC/HMI to display. After about an...
Replies
1
Views
119
Ken Roach
Ken Roach
Back
Top Bottom