I'm trying to use a Red Lion Cub counter (Cub5B00) as a counter and give the cub's counts to a Graphite G12 PLC/HMI to display. After about an hour of the plc being on, I lose connection to the cub and I don't see the data communication light (red light) on the RS485 port. I however still have the green flashing on the rs485 port.
Red Lion Graphite G12-RS485 port loses connection to Red Lion Cub
- Thread starter Nman
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
Welcome to the PLCTalk forum community !
What driver are you using to communicate between the Cub5B00 and the Graphite G12 ?
Are you visualizing or enabling any error counters or diagnostics for the driver ?
What driver are you using to communicate between the Cub5B00 and the Graphite G12 ?
Are you visualizing or enabling any error counters or diagnostics for the driver ?
Similar Topics
Does anyone know a quick answer to the difference of a red lion G10C1000 vs G10C0000. In crimson it shows an aux ethernet port. on the web site i...
Hello all. I am struggling with an analog output from a Red Lion Graphite HMI with a GMOUT4 module. I can watch what the data should be (currently...
I have a graphite HMI and 3 PAX panel meters.
I have tried using RLC and Modbus Master drivers, 2 different cables, with and without Comm...
Hi Everyone,
Got a new project where I am going to read the level of a tank via Modbus and I need to use the tank strapping chart to convert it to...
Hey folks, I have a Graphite display that had water dripping inside. The display powers on to the initial graphite start up screen and then...