I have a new eprom 64 k that was loaded with an s5 std file....
The problem is , the card will be on the run stop mode and cp fault removed. However, there is still no communication between the cpu 928b and the CP ....
The L2 address as given by the programmer based on our back up program is zero and base address is also zero...
The PG 720 tool L2 address range is bet 1 and 256.... so we tried 1 as L2 and base zero and had the above result....
Can anybody explain the rfault indication?????
regards,
Fidel
The problem is , the card will be on the run stop mode and cp fault removed. However, there is still no communication between the cpu 928b and the CP ....
The L2 address as given by the programmer based on our back up program is zero and base address is also zero...
The PG 720 tool L2 address range is bet 1 and 256.... so we tried 1 as L2 and base zero and had the above result....
Can anybody explain the rfault indication?????
regards,
Fidel
