cschwartzman
Member
Hey folks!
Bumping into the most basic and annoying of problems. My Micro850 isn't reading inputs and it isn't enabling outputs. I used a jumper wire from the +24v power terminal to _IO_EM_DI_00 and, while the power light and the RUN light is lit up, the corresponding input led doesn't turn on.
My program, such as it is, consists of a normally open contact (_IO_EM_DI_00) in series with a single coil (_IO_EM_DO_00), which was built and uploaded to the PLC before testing.
Ideas? Tutorials? Is it possible the PLC is ****ed up? Is there a factory reset option somewhere that I can't see?
Help, please :/
Bumping into the most basic and annoying of problems. My Micro850 isn't reading inputs and it isn't enabling outputs. I used a jumper wire from the +24v power terminal to _IO_EM_DI_00 and, while the power light and the RUN light is lit up, the corresponding input led doesn't turn on.
My program, such as it is, consists of a normally open contact (_IO_EM_DI_00) in series with a single coil (_IO_EM_DO_00), which was built and uploaded to the PLC before testing.
Ideas? Tutorials? Is it possible the PLC is ****ed up? Is there a factory reset option somewhere that I can't see?
Help, please :/