Qulu Quliyev
Member
Hi everyone,
I am beginner in the plc programming, and I am learning it using SoMachine basic software. There is a comparison command, which I have problem to work
with that. I want to compare two bits, and write the valid expression in below form:
[%Q0.0=%M0]
However, software gives me error. Can anyone help me with that ?
Any help is highly appreciated.
Best Regards,
I am beginner in the plc programming, and I am learning it using SoMachine basic software. There is a comparison command, which I have problem to work
with that. I want to compare two bits, and write the valid expression in below form:
[%Q0.0=%M0]
However, software gives me error. Can anyone help me with that ?
Any help is highly appreciated.
Best Regards,