Hi all,
I'm trying to interface a mettler toledo ind570 to a SLC PLC via a SST-PFB-SLC profibus card.
It's a single scale where all the tare, net weight calculations is done within PLC, so I'm only after floating point indication for gross weight.
The Mettler is currently set up with:
Setup > Communication > PLC > Profibus > Shared data - Disabled
Setup > Communication > PLC > Data Format > Operating Mode - Compability
Setup > Communication > PLC > Data Format > Floating Point - Enabled
Setup > Communication > PLC > Data Format > Byte Order - Standard
Setup > Communication > PLC > Data Format > Message Slots - 1
The SST-PFB-SCL is set up with:
4 words in
4 words out
Anybody has any experience with this? Does the byte order and message slot setting seem correct? Or would I need to swap bytes when communicating with SLC?
Best regards
I'm trying to interface a mettler toledo ind570 to a SLC PLC via a SST-PFB-SLC profibus card.
It's a single scale where all the tare, net weight calculations is done within PLC, so I'm only after floating point indication for gross weight.
The Mettler is currently set up with:
Setup > Communication > PLC > Profibus > Shared data - Disabled
Setup > Communication > PLC > Data Format > Operating Mode - Compability
Setup > Communication > PLC > Data Format > Floating Point - Enabled
Setup > Communication > PLC > Data Format > Byte Order - Standard
Setup > Communication > PLC > Data Format > Message Slots - 1
The SST-PFB-SCL is set up with:
4 words in
4 words out
Anybody has any experience with this? Does the byte order and message slot setting seem correct? Or would I need to swap bytes when communicating with SLC?
Best regards