Hi, All!
I am very new to PLCs and I am currently writing ladder logic for an Allen bradley MLX1200.
I have a number of inputs which i have addressed in the format: I:1.0/1 etc. which should equate to I:Slot.Word/Terminal.
I have checked the SLC 500 Instruction Set document which has informed me that this format should be structured correctly however I still receive the error message "ERROR: Address must be specified to the word level!"
Can anyone see where I am going wrong?
For reference Slot 1 is a 4-Channel Thermocouple Input Module (1762-IT4).
Any help would be greatly appreciated.
Thanks
C
I am very new to PLCs and I am currently writing ladder logic for an Allen bradley MLX1200.
I have a number of inputs which i have addressed in the format: I:1.0/1 etc. which should equate to I:Slot.Word/Terminal.
I have checked the SLC 500 Instruction Set document which has informed me that this format should be structured correctly however I still receive the error message "ERROR: Address must be specified to the word level!"
Can anyone see where I am going wrong?
For reference Slot 1 is a 4-Channel Thermocouple Input Module (1762-IT4).
Any help would be greatly appreciated.
Thanks
C