Hi guys:
I have two Stratix switch, one 8300 layer 3 switch and another 8000 switch downstream.
I created VLAN 60,61 at 8000 switch by below command.
- EN
- Conf t
- Vlan 60
- Exit
- Conf t
- Vlan 61
- Exit
At the 8300 switch, I created VLAN through IExplorer and defined IP address, and subnet mask. Note there is already some other VLANs defined at this switch.
Then I choose one port at each switch, use below command to set it to trunk.
-EN
-Conf t
-Int F2/2 (for example)
-switchport mode trunk
When I have all my cable in place, I cannot ping to each other, and the syslog on the 8000 switch says "Native VLAN mismatch".
What is Native VLAN? Do I need to set it?
I have two Stratix switch, one 8300 layer 3 switch and another 8000 switch downstream.
I created VLAN 60,61 at 8000 switch by below command.
- EN
- Conf t
- Vlan 60
- Exit
- Conf t
- Vlan 61
- Exit
At the 8300 switch, I created VLAN through IExplorer and defined IP address, and subnet mask. Note there is already some other VLANs defined at this switch.
Then I choose one port at each switch, use below command to set it to trunk.
-EN
-Conf t
-Int F2/2 (for example)
-switchport mode trunk
When I have all my cable in place, I cannot ping to each other, and the syslog on the 8000 switch says "Native VLAN mismatch".
What is Native VLAN? Do I need to set it?