castro
Member
I have a setup with a Trio Motion Coordinator MC206, Simple Servo Drive SS608 and an advanced Digital Servo Motor 523-20-F430.
The project in mind is to be able to start the TRIO motion programs from a CJ1M PLC. An operator will set a reference speed through an HMI (CX-Supervisor).
How do I communicate the Trio Motion controller with the CJ1M?
Is ethernet an option? OMRON ETN11 Ethernet module & Trio Ethernet daughter board
The project in mind is to be able to start the TRIO motion programs from a CJ1M PLC. An operator will set a reference speed through an HMI (CX-Supervisor).
How do I communicate the Trio Motion controller with the CJ1M?
Is ethernet an option? OMRON ETN11 Ethernet module & Trio Ethernet daughter board