jimcav
Member
Good Morning
I have been given the task of making a new control panel for one of our rite hite door controllers. It uses an Omron plc I dont have the software to extract the program. I was wondering if anyone has done this before. The operation seems straight forward but there might be something I did not think about, even just a PDF to look at would be good. I will also take any advice. I know its a door that goes up and down but I value what is said here it will be worth considering when i start writing a new program.
Thanks
Jim Cav
I have been given the task of making a new control panel for one of our rite hite door controllers. It uses an Omron plc I dont have the software to extract the program. I was wondering if anyone has done this before. The operation seems straight forward but there might be something I did not think about, even just a PDF to look at would be good. I will also take any advice. I know its a door that goes up and down but I value what is said here it will be worth considering when i start writing a new program.
Thanks
Jim Cav