The helping soul can be ME!
But, before anything else. I want to know who made the shrink wrapper.
It has built w/ RS5000 so I felt I might know who did. I'm end-user too and have shrink wrapper. IF PLC logic was never right 1st place, maybe it is time to fix once for all.
Typical my shrink wrapper problem;
The latching output of cylinder valve is sticking while the transfer push is active. In this case, I changed logic, so it doesn't interfere each other using sequential logics. Also, time to time, confusing TOF vs. TON vs. RTO timers conjuntion w/ transfer push delay. Well, even in this case, I had to change TOF to TON and make counter and RTO reset bit(Clear bit) use to re-arrange logics.