Hi
I have a powerflex 525 on my desk and a clx plc and have foolowed the AB quickstart procedure
I have added the powerflex and can see it from logix and can create and reset alarms so comms is up
in the quick start it says to set parameter 46 and 47 to Ethernet IP
If I set FreqCommand to 150000 and set Start to 1 nothing happens.
The drive is NOT in fault
Any ideas how to get the drive to go into run
I have a powerflex 525 on my desk and a clx plc and have foolowed the AB quickstart procedure
I have added the powerflex and can see it from logix and can create and reset alarms so comms is up
in the quick start it says to set parameter 46 and 47 to Ethernet IP
If I set FreqCommand to 150000 and set Start to 1 nothing happens.
The drive is NOT in fault
Any ideas how to get the drive to go into run