PLCS.net - Interactive Q & A - View Single Post - Change IP on 1788-ENBT flexlogix L34

dmargineau · October 17th, 2019, 03:04 PM

I doubt you'd be able to use RSLinx to edit the 1788-ENBT IP Address; said address is defined and hard-coded within the RSL5K application running on the controller.

Your best bet would be to connect to the CPU via the controller's Serial RS232 port using a DF-1 driver and upload the application presuming, of course, you are running RSL5K of the same version as the CPU firmware level.

October 17th, 2019, 03:04 PM	#2
dmargineau Lifetime Supporting Member Join Date: Dec 2011 Location: Midwest Posts: 2,463	I doubt you'd be able to use RSLinx to edit the 1788-ENBT IP Address; said address is defined and hard-coded within the RSL5K application running on the controller. Your best bet would be to connect to the CPU via the controller's Serial RS232 port using a DF-1 driver and upload the application presuming, of course, you are running RSL5K of the same version as the CPU firmware level.