I`m trying to command a Mitsubishi inverter F800 using a Micrologix PLC with message instructions.
I sucessfully controled it using a Compact Logix with a EDS file.
Opening the EDS file i have these information:
[Params]
Param1 =
0, $ reserved, shall equal 0
6,"20 29 24 01 30 03", $ Link Path Size, Link Path
0x0000, $ Descriptor
0xC1, $ Data Type
1, $ Data Size in bytes
"Run forward", $ name
"", $ units
"Run forward", $ help string
0,1,0, $ min, max, default data values
,,,, $ mult, div, base, offset scaling
,,,, $ mult, div, base, offset links
0; $ decimal places
Is possible to decode the "link path" to send information using message or another instruction ?
I sucessfully controled it using a Compact Logix with a EDS file.
Opening the EDS file i have these information:
[Params]
Param1 =
0, $ reserved, shall equal 0
6,"20 29 24 01 30 03", $ Link Path Size, Link Path
0x0000, $ Descriptor
0xC1, $ Data Type
1, $ Data Size in bytes
"Run forward", $ name
"", $ units
"Run forward", $ help string
0,1,0, $ min, max, default data values
,,,, $ mult, div, base, offset scaling
,,,, $ mult, div, base, offset links
0; $ decimal places
Is possible to decode the "link path" to send information using message or another instruction ?