Shevy
Member
This is my first posting:
I have Problems with Uploading a Panel View 550 connected to an SLC 5/03
Allen Bradley SLC 5/03 1747-L532 PLC
Connected over DH485 Channel 1 using C10 cable
to a Panel View 550 Cat 2711-K5A2 Ser C, Rev A & FRN 1.07 (no RS232 port)
RS Linx Version 2.54
RS Logix 500 Pro Version 8.10
Panel Builder 32 Version 3.82.01
It seem that the Panel View 550 Cat 2711-K5A2 Ser C, Rev A & FRN 1.07 will not recognise the memory card slot.
I have managed to upload the SLC program using the DH485 port on the Panel View 550 using a 1747-PIC cable (PIC driver).
However, I cannot upload the Panel View 550 program using Panel Builder 32 and the 1747-PIC cable.
The uploading gets to 99% of the way then displays the following error code;
Error Code 4008 Terminal Reported Bad Data Count
How can I get round this problem and upload from the Panel View 550?
Can anyone help?
I have Problems with Uploading a Panel View 550 connected to an SLC 5/03
Allen Bradley SLC 5/03 1747-L532 PLC
Connected over DH485 Channel 1 using C10 cable
to a Panel View 550 Cat 2711-K5A2 Ser C, Rev A & FRN 1.07 (no RS232 port)
RS Linx Version 2.54
RS Logix 500 Pro Version 8.10
Panel Builder 32 Version 3.82.01
It seem that the Panel View 550 Cat 2711-K5A2 Ser C, Rev A & FRN 1.07 will not recognise the memory card slot.
I have managed to upload the SLC program using the DH485 port on the Panel View 550 using a 1747-PIC cable (PIC driver).
However, I cannot upload the Panel View 550 program using Panel Builder 32 and the 1747-PIC cable.
The uploading gets to 99% of the way then displays the following error code;
Error Code 4008 Terminal Reported Bad Data Count
How can I get round this problem and upload from the Panel View 550?
Can anyone help?