Need help to start FIX 7.0

Raffe

Member
R
Join Date
Apr 2017
Location
Sweden
Posts
26
Hello,

I need some help from you guys to open an FIX32 Project that I got. What are the steps?

1. In the system configuration should the path point to the Ppoject or the installation of FIX32?

2. Should I change the local setup to Point to my SCU project file?

3. Any thing I need to do before start the "Startup" ?

Regards
Raffe
 

Similar Topics

dalporto
InTouch Start-Up / Setup - Need help
Hi everybody. This is part number 3 of my new project with stuff we don't usually work with. Thanks to everyone who takes time to answer, it's...
Replies
10
Views
1,677
dalporto
dalporto
D
Need Help with Powerflex 40, won't start.
Previously, i interfaced PowerFlex 40 with SLC 505 processor via Ethenet IP. At some point i had a timeout error message. After this point, the...
2
Replies
17
Views
7,489
OkiePC
OkiePC
O
Need help to idiot proof a Start button
OK program starts a convoyer systems, Idiot boy hit start/stop at least twenty times in 30 seconds jams up motor....Is there a way i can have it...
2 3 4
Replies
54
Views
14,168
OkiePC
OkiePC
A
need help
I was wondering if anyone could help i am trying to use a SLC 500 with a 5/05 processor to set up an incremental encoder to a HSCE2 card? The card...
Replies
2
Views
154
adam 1432
A
T
Anyone here work for Johnson Controls now or in the past?...need help with OLD PLC program
I have an old Sentry Palletizer (S/O Number 3007 / Serial Number 1172) that has lost its program as the backup battery died years ago. I can...
Replies
0
Views
161
TheCaptain2000
T
Back
Top Bottom