htariq
Member
Hi all,
I'm working on an FX1S-10MR-ES PLC where there are 6 inputs (X000-X005) and 4 outputs (Y000-Y003). I used the programming from another PLC to reapply it so I studied that programming. In that program, X006 and X007 were used although these aren't even on the hardware also the inputs X000 or X001 were not used. What can be the reason behind this?
Is there some kind of trick that turns X006 to X000 and X007 to X001 or are these just tricks to confuse anyone trying to access that program?
(P.S Y004 was also used in the program when it isn't even or hardware)
(I have attached the program, this is a simple program of opening a door based on sensors and manual buttons)
I'm working on an FX1S-10MR-ES PLC where there are 6 inputs (X000-X005) and 4 outputs (Y000-Y003). I used the programming from another PLC to reapply it so I studied that programming. In that program, X006 and X007 were used although these aren't even on the hardware also the inputs X000 or X001 were not used. What can be the reason behind this?
Is there some kind of trick that turns X006 to X000 and X007 to X001 or are these just tricks to confuse anyone trying to access that program?
(P.S Y004 was also used in the program when it isn't even or hardware)
(I have attached the program, this is a simple program of opening a door based on sensors and manual buttons)