Good Afternoon ,
I would like to get much more fluid with changing out PowerFlex 753 Drives. The Powerflex 753 drives that we have are mostly FW 9.001 and replacing them with 14.002. This is what I have been doing .
1. Enter the IP Address , Subnet and Gateway on the keypad for the 20-750
ENETR card.
2. In RS Logix 5000 Tree , select the drive , right click , select properties .
Select Change . You use Match Drive , correct ? Match Drive only appears
Bold when RS Logix 5000 is Offline ? When you select Match Drive , that
changes the firmware from 9.001 to 14.0 in the program ( PLC ) correct ?
3. Once you do that , it seems like it wants you to upload or download . I
guess you download , because you tell the PLC what firmware the new
drive will have ? When do you actually download the parameters to the
new drive ? I guess you use the Drive Tab , and then it Correlates in that
tab. Is that where you download to the drive ? Are the parameters in
the PLC program , or CCW ?
Thanks so much in advance ,
I would like to get much more fluid with changing out PowerFlex 753 Drives. The Powerflex 753 drives that we have are mostly FW 9.001 and replacing them with 14.002. This is what I have been doing .
1. Enter the IP Address , Subnet and Gateway on the keypad for the 20-750
ENETR card.
2. In RS Logix 5000 Tree , select the drive , right click , select properties .
Select Change . You use Match Drive , correct ? Match Drive only appears
Bold when RS Logix 5000 is Offline ? When you select Match Drive , that
changes the firmware from 9.001 to 14.0 in the program ( PLC ) correct ?
3. Once you do that , it seems like it wants you to upload or download . I
guess you download , because you tell the PLC what firmware the new
drive will have ? When do you actually download the parameters to the
new drive ? I guess you use the Drive Tab , and then it Correlates in that
tab. Is that where you download to the drive ? Are the parameters in
the PLC program , or CCW ?
Thanks so much in advance ,