nightline
Member
Gents,
I've an Allen Bradley Kinetix 6000 Sercos servo system with 2 motors on a rigid construction.
Both motors have the same gear ratio to the construction.
I connect both motors with a MAG instruction with a ratio 1:1.
When I start a motion instruction there appears a great difference in torque feedback between both motors, something like 250 for the master and 50 for the slave.
What can cause this?
Thanks in advance!
Jack
I've an Allen Bradley Kinetix 6000 Sercos servo system with 2 motors on a rigid construction.
Both motors have the same gear ratio to the construction.
I connect both motors with a MAG instruction with a ratio 1:1.
When I start a motion instruction there appears a great difference in torque feedback between both motors, something like 250 for the master and 50 for the slave.
What can cause this?
Thanks in advance!
Jack