Electricfred13
Member
Good afternoon,
I am trying to write code that can select between a PID and just triggering an on/off state on the same output. The output would be on an analog O:1.1
I am trying to switch from a NC Binary Data file to a NO Binary data file that jumps to the PID. So basically when I want PID control I switch to NO when I want just a high state without PID I switch back to NC Binary. This would be for a selector switch.
Am I approaching this correctly? And what is the conventional approach to switching output states to and from a PID instruction?
Thank you
-E
I am trying to write code that can select between a PID and just triggering an on/off state on the same output. The output would be on an analog O:1.1
I am trying to switch from a NC Binary Data file to a NO Binary data file that jumps to the PID. So basically when I want PID control I switch to NO when I want just a high state without PID I switch back to NC Binary. This would be for a selector switch.
Am I approaching this correctly? And what is the conventional approach to switching output states to and from a PID instruction?
Thank you
-E