chippieboy
Member
Hi all, I recently purchased a machine that has/had 2MicroLogix 1000 PLC's with 2 MicroViewpanels.
The previous owner stripped out one of the PLC's and one ofthe MicroView panels. To revamp this machine with new panels/program it would cost morethan it is worth, therefore I need to replace the missing MicroView Panel andprogram the replacement Panel with the same program that is in the existingMicroView panel. The big problem is finding the 2707-NP or 2707-NP2 software orsomeone to program the device for me. Any ideas?
Thanks in advance
Chip
The previous owner stripped out one of the PLC's and one ofthe MicroView panels. To revamp this machine with new panels/program it would cost morethan it is worth, therefore I need to replace the missing MicroView Panel andprogram the replacement Panel with the same program that is in the existingMicroView panel. The big problem is finding the 2707-NP or 2707-NP2 software orsomeone to program the device for me. Any ideas?
Thanks in advance
Chip