I need some controllogic code to create this flow curve
Been trying to figure out a way to do this is a clean and
accurate manner.
The analog input module is configured for 4-20 ma = 0-100 inches of H20
The physical calibrated flow measurements come out to this
0 0 LBM/H
10 8222 LBM/H
20 11628 LBM/H
30 14241 LBM/H
40 16444 LBM/H
50 18385 LBM/H
60 20140 LBM/H
70 21753 LBM/H
80 23255 LBM/H
90 24666 LBM/H
100 26000 LBM/H
as you can see even tho the 0-100 inches of h20 across
the orifice place is linear, the actual volume of material
is not. So I need a code snipit that can produce this curve.
Willing to compensate for the time, I need it by Monday Morning
Thanks
Been trying to figure out a way to do this is a clean and
accurate manner.
The analog input module is configured for 4-20 ma = 0-100 inches of H20
The physical calibrated flow measurements come out to this
0 0 LBM/H
10 8222 LBM/H
20 11628 LBM/H
30 14241 LBM/H
40 16444 LBM/H
50 18385 LBM/H
60 20140 LBM/H
70 21753 LBM/H
80 23255 LBM/H
90 24666 LBM/H
100 26000 LBM/H
as you can see even tho the 0-100 inches of h20 across
the orifice place is linear, the actual volume of material
is not. So I need a code snipit that can produce this curve.
Willing to compensate for the time, I need it by Monday Morning
Thanks