swapnil.naik
Member
We are using Simocode (Motor Management System) and facing an issue while running a STAR-DELTA Starter
Attached are the drawings for your reference along with the simocode program
We have kept Max Star to Delta changeover time as 10sec
When we check the feeder without Load (No motor load connected), The changeover time is observed as 10 sec
But when we connect actual motor and start the feeder
The changeover from Star to Delta is not 10sec but it happens at around 2 to 2.5 sec
Is the changeover current dependent?
How can we make it to work with only timer (10sec)
Thanking you in advance for your help and support
Attached are the drawings for your reference along with the simocode program
We have kept Max Star to Delta changeover time as 10sec
When we check the feeder without Load (No motor load connected), The changeover time is observed as 10 sec
But when we connect actual motor and start the feeder
The changeover from Star to Delta is not 10sec but it happens at around 2 to 2.5 sec
Is the changeover current dependent?
How can we make it to work with only timer (10sec)
Thanking you in advance for your help and support
Last edited: