Manglemender
Member
Hello,
I have a current project that involves adding a new load cell amplifier to an existing machine control system. Adding new analogue inputs to the existing I/O is a possibility but I noted that the device can communicate by UDP and wondered if there were any examples/advice out there.
I did find an example of two PLCs communication over UDP: https://support.industry.siemens.co...rface-of-an-s7-300-s7-400-cpu-?dti=0&lc=en-WW
CPU S7 317PN/DP programmed with Simatic Manager V5.5 and also has an MP270 HMI programmed with WinccFlexible2008.
The goal is to display measured tensions on the HMI.
Thanks in advance,
Nick
I have a current project that involves adding a new load cell amplifier to an existing machine control system. Adding new analogue inputs to the existing I/O is a possibility but I noted that the device can communicate by UDP and wondered if there were any examples/advice out there.
I did find an example of two PLCs communication over UDP: https://support.industry.siemens.co...rface-of-an-s7-300-s7-400-cpu-?dti=0&lc=en-WW
CPU S7 317PN/DP programmed with Simatic Manager V5.5 and also has an MP270 HMI programmed with WinccFlexible2008.
The goal is to display measured tensions on the HMI.
Thanks in advance,
Nick