Programmable Overload/Controllers...

bluenoser337

Member
bluenoser337
Join Date
Apr 2003
Location
Nova Scotia
Posts
391
Is anyone using a programmable overload that talks Modbus TCP (for use with upgraded Unity Pro Momentum CPUs)? I see the Schneider Tesys T Motor Management system controllers are compatible, but looking for other options to consider. :p
 

Similar Topics

C
Help with old CUTLER-HAMMER D100 Programmable controller
Hi everyone, I know this is an old one but we have a d100 in our wrapper , it just stopped working. When the inputs are pressed the corresponding...
Replies
3
Views
253
carlos1984
C
N
OLD FEAC PC-116-24 Programmable position control - Manual?
Hello all, I have an old machine that utilizes two FEAC PC-116-24 controllers used for position monitoring and output to an OMORM CQM1 PLC. I did...
Replies
1
Views
641
Nortkan KC1
N
cjarvis64
AB 440CR30 Programmable Safety Relay
Working with this unit for the first time, is there a way to make this unit behave like a safety relay, as in break a PLC output based on inputs...
Replies
14
Views
3,109
g.mccormick
G
K
Looking for a simple non-programmable message display
I'm working on a fairly simple project where I need the ability to display some basic fault messages. The scope of this project does not justify...
2
Replies
21
Views
2,687
Lare
L
C
IDEC FA-2J Programmable Controller Software and Communication Cable
Does anyone know what software the IDEC FA-2J Controller uses? And what cable is needed to communicate? I can barely find any information on this...
Replies
2
Views
1,143
Cody Anderson
C
Back
Top Bottom