I am working on different ways I can set up a Modbus topology for the comm's.
I have 2 different cables from AD that can go to the drives, One is 6 pin IEEE
to RJ12 and the other is 6 pin IEEE to tinned ends. I would prefer the RJ12
ended cables and use a ziplink breakout board (also AD) My problem is tring to
find the pinout requirements to go from 8 pin mini DIN (Micrologix 1400) for
Channel 0 to use with the Automation Direct SVC-232RJ12-CBL-2
If any one has suggestion I would appreciate. I have looked up the pinouts for the various AB cables used for the 8 pin mini din as well as a post here using a
1763 NC01 cable to the tinned end IEEE cable and I come up with conflicting pinouts from the Mini DIN.
Still working together-6 feet apart- Thanks
I have 2 different cables from AD that can go to the drives, One is 6 pin IEEE
to RJ12 and the other is 6 pin IEEE to tinned ends. I would prefer the RJ12
ended cables and use a ziplink breakout board (also AD) My problem is tring to
find the pinout requirements to go from 8 pin mini DIN (Micrologix 1400) for
Channel 0 to use with the Automation Direct SVC-232RJ12-CBL-2
If any one has suggestion I would appreciate. I have looked up the pinouts for the various AB cables used for the 8 pin mini din as well as a post here using a
1763 NC01 cable to the tinned end IEEE cable and I come up with conflicting pinouts from the Mini DIN.
Still working together-6 feet apart- Thanks