Hello, I'm a electrician who is furthering my education and learning to be a programer , I have a Dell laptop running windows 7 with rs logics pro and rs linxs classic , I'm having problems connecting to a slc 500 processor I purchased on line ,
To connect to the plc I'm using a after market chinese 1747 uic controller plugging into the 485 port ,
The plc has been factory reset , and is blinking red fault because it dosnt have a program in it, [ I did replace the battery)
Anyways every time I try to go online or download a program into the processor , I get a error that " communications is not responding ' and either rs linxs crashes or rs logixs does , either way I've yet to communicate with the plc
Note , in whos online in linx and logix the plc is showing up without a red x, and the 485 light on my processor is green, and the baud rate is set at 19200, also I've tried another processor and have the same problem, and I double checked that the brogram is verifred and the project io modules are correct ,
Any help will be greatly apreciated
To connect to the plc I'm using a after market chinese 1747 uic controller plugging into the 485 port ,
The plc has been factory reset , and is blinking red fault because it dosnt have a program in it, [ I did replace the battery)
Anyways every time I try to go online or download a program into the processor , I get a error that " communications is not responding ' and either rs linxs crashes or rs logixs does , either way I've yet to communicate with the plc
Note , in whos online in linx and logix the plc is showing up without a red x, and the 485 light on my processor is green, and the baud rate is set at 19200, also I've tried another processor and have the same problem, and I double checked that the brogram is verifred and the project io modules are correct ,
Any help will be greatly apreciated