jthornton
Member
Can someone clarify the BSL instruction for me?
Length is that in bits or words?
If length is in bits why select any number below 16 as the instructions say that Bits located to the left of the last bit in the array, up to the next word boundary cannot be used.
Maybe I'm just looking at the wrong instruction....
I have 5 stations when the indexer cycles all stations move one step.
1 > 2, 2 > 3, 3 > 4, 4 > 5, 5 out
This leaves Station 1 empty until it is filled by the operator.
I want to track the status of each station each time I cycle the indexer. If I don't have to use a whole word to do this it will be better as I am using a L511 1k memory processor.
Length is that in bits or words?
If length is in bits why select any number below 16 as the instructions say that Bits located to the left of the last bit in the array, up to the next word boundary cannot be used.
Maybe I'm just looking at the wrong instruction....
I have 5 stations when the indexer cycles all stations move one step.
1 > 2, 2 > 3, 3 > 4, 4 > 5, 5 out
This leaves Station 1 empty until it is filled by the operator.
I want to track the status of each station each time I cycle the indexer. If I don't have to use a whole word to do this it will be better as I am using a L511 1k memory processor.