Hello,
I am trying to connect a PLC (Matsuhita Nais FP1 C40) to FPWIN Pro. I have the programming cable USB 8550. I installed the driver for the cable and I can see that it is installed correct (CH340 COM3).
When I open FPWIN Pro 7 I try to create a project from PLC. It shows that the PLC is in prog mode and after few seconds it displays an error, the error is in german so I translate it: "An error occurred in online mode:Comment memory does not exist"
I used also FPWIN GR when I try to download from PLC to my computer I get the error "42 From PLC : Basic procedure error - Non-supported error" and it prompts "the upload from the PLC was completed successfully.
Does someone know what to do? Am I doing something wrong?
I am trying to connect a PLC (Matsuhita Nais FP1 C40) to FPWIN Pro. I have the programming cable USB 8550. I installed the driver for the cable and I can see that it is installed correct (CH340 COM3).
When I open FPWIN Pro 7 I try to create a project from PLC. It shows that the PLC is in prog mode and after few seconds it displays an error, the error is in german so I translate it: "An error occurred in online mode:Comment memory does not exist"
I used also FPWIN GR when I try to download from PLC to my computer I get the error "42 From PLC : Basic procedure error - Non-supported error" and it prompts "the upload from the PLC was completed successfully.
Does someone know what to do? Am I doing something wrong?