ishoottrap
Member
Hi,
I'm trying to figure out how to use the SG2 modbus slave mode to both set a value in a register as well as set a single coil. It appears that the slave device will receive data into the data register addressed by the master, is there any way to simulate this using the TECO tools?
Also, what address does the master device use when setting a single coil and what is the setup in the slave device?
I'm trying to figure out how to use the SG2 modbus slave mode to both set a value in a register as well as set a single coil. It appears that the slave device will receive data into the data register addressed by the master, is there any way to simulate this using the TECO tools?
Also, what address does the master device use when setting a single coil and what is the setup in the slave device?