George07
Member
Hi
I'm trying to use a ControlLogix PLC to read from a Micrologix 1100 PLC via messaging.
I've setup this before at in my office and worked fine.
When I tried the same setup on another pair of ControlLogix and Micrologix it doesn't work.
All in all I'm trying to let 4 ControlLogix PLC's to read from the Micrologix
EtherNet Adresses For ControlLogix: 100.100.100.16, 100.100.100.17, 100.100.100.18, 100.100.100.19. All Subnet 255.255.255.0
EtherNet Adresses For Micrologix: 100.100.100.99 Subnet 255.255.255.0
it gives me and error path.
I know the 1, 2, 3, 100.100.100.100 format where
1 - is base
2 - slot
3 - remote or local
100.100.100.100 of remote device
ControlLogix in SLC Typed Read
my current settings are 1, 6, 2,100.100.100.99 and it doesnt work. is there any other small setting I'm missing?
Thank you in advance
I'm trying to use a ControlLogix PLC to read from a Micrologix 1100 PLC via messaging.
I've setup this before at in my office and worked fine.
When I tried the same setup on another pair of ControlLogix and Micrologix it doesn't work.
All in all I'm trying to let 4 ControlLogix PLC's to read from the Micrologix
EtherNet Adresses For ControlLogix: 100.100.100.16, 100.100.100.17, 100.100.100.18, 100.100.100.19. All Subnet 255.255.255.0
EtherNet Adresses For Micrologix: 100.100.100.99 Subnet 255.255.255.0
it gives me and error path.
I know the 1, 2, 3, 100.100.100.100 format where
1 - is base
2 - slot
3 - remote or local
100.100.100.100 of remote device
ControlLogix in SLC Typed Read
my current settings are 1, 6, 2,100.100.100.99 and it doesnt work. is there any other small setting I'm missing?
Thank you in advance