jimtech67
Member
I have a Emerson Motion Controller
Control Techniques Ei202 servo drive Indexing
With motor NTE-207-CONS Brushless servo motor
Issue 1
Every so often the drive powers loses its application program.
Using Power Tool FM v4.2 I download the application and
then operation is normal.
Issue2
Every so often I get fault u (Low DC Bus)
The fault will not reset
after a period of time. (Drive is powered during this time)
The fault can be reset ..
The drive is powered with 120VAC single phase.
During the fault period I measure the following
118 VAC acrross LI and L2
156 VDC across the BUS (+ -)
The customer said they have power issues but could no elaborate any further.
Any suggestions or has anyone else experienced this ????
Control Techniques Ei202 servo drive Indexing
With motor NTE-207-CONS Brushless servo motor
Issue 1
Every so often the drive powers loses its application program.
Using Power Tool FM v4.2 I download the application and
then operation is normal.
Issue2
Every so often I get fault u (Low DC Bus)
The fault will not reset
after a period of time. (Drive is powered during this time)
The fault can be reset ..
The drive is powered with 120VAC single phase.
During the fault period I measure the following
118 VAC acrross LI and L2
156 VDC across the BUS (+ -)
The customer said they have power issues but could no elaborate any further.
Any suggestions or has anyone else experienced this ????