dskplc
Member
Hi,
I have been tasked to test JSR/SBR instructions using parameters in RSLogix 5000. I found a video that was extremely helpful using 1 parameter in the JSR instruction going to the 1 parameter in SBR. I need to use 4 parameters in the SBR (no RET) and am assuming I will need 4 parameters in the JSR also?
I have not done this before so can use any advice possible. I have read the Rockwell manual for general instructions but am still lost. Thanks in advance for your help.
I have been tasked to test JSR/SBR instructions using parameters in RSLogix 5000. I found a video that was extremely helpful using 1 parameter in the JSR instruction going to the 1 parameter in SBR. I need to use 4 parameters in the SBR (no RET) and am assuming I will need 4 parameters in the JSR also?
I have not done this before so can use any advice possible. I have read the Rockwell manual for general instructions but am still lost. Thanks in advance for your help.