Using Cscape and Horner XL4 OCS

unsaint33

Member
U
Join Date
Sep 2019
Location
MInnesota
Posts
118
Hi I'm new on Horner PLC XL4 OCS using Cscape software. After establishing ethernet comm I can upload/download program to/from the XL4 just fine. But how do I go online and monitor the rungs online? Thank you.
 

Similar Topics

J
simulation setup using horner OCS using structured text (Cscape)
I am trying to set up a piece of equipment with a Horner HE-X4R. I'd like to use structured text and so far I'm just trying to get a basic On/off...
Replies
0
Views
105
jdk202
J
S
How to read the configuration of the AB 1769 L33ER PLC by CIP protocol , using socket without Studio 5000 or Logix5000
Hello, We are now working on a software to collet the configuration of different PLC brands ,using a third software to backup all the simens...
Replies
6
Views
124
Stone.Zhang
S
L
Sequence loop using EQU and MOV instructions
Hi, I wrote a sequence loop using EQU and MOV instructions and would like to validate that i'm doing this properly. i attached a picture of the...
Replies
8
Views
175
parky
P
W
Reasons for using Tc2_NcFifoAxes?
Hi I'm very new to PLC programming and I'm trying to find out if this library (Tc2_NcFifoAxes) is necessary for our task In our case we need to...
Replies
0
Views
50
wopadidoo123
W
A
ATS using a PLC
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...
Replies
0
Views
95
Alibaba07
A
Back
Top Bottom