Using Cscape and Horner XL4 OCS

unsaint33

Member
U
Join Date
Sep 2019
Location
MInnesota
Posts
118
Hi I'm new on Horner PLC XL4 OCS using Cscape software. After establishing ethernet comm I can upload/download program to/from the XL4 just fine. But how do I go online and monitor the rungs online? Thank you.
 

Similar Topics

J
simulation setup using horner OCS using structured text (Cscape)
I am trying to set up a piece of equipment with a Horner HE-X4R. I'd like to use structured text and so far I'm just trying to get a basic On/off...
Replies
0
Views
72
jdk202
J
W
Reasons for using Tc2_NcFifoAxes?
Hi I'm very new to PLC programming and I'm trying to find out if this library (Tc2_NcFifoAxes) is necessary for our task In our case we need to...
Replies
0
Views
28
wopadidoo123
W
A
ATS using a PLC
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...
Replies
0
Views
64
Alibaba07
A
T
Using Patch Panels in Control Panels
Adding ethernet equipment to an existing panel that has none. We have some solid ethernet cables coming from other remote cabinets that I plan to...
Replies
3
Views
125
nicherbert
N
K
RS485 Modbus RTU using PC com port in Twincat 3 issues
I'm trying to control a device via MODBUS RTU and the ModbusRtuMasterV2_PcCOM in Twincat 3. I've configured a device with the right com port and...
Replies
7
Views
225
Jkoso
J
Back
Top Bottom