I have a program that has motor status codes in the logic. I have attached screen shots. I for the life of me do not see where these things go or what they do. I understand what they should do, but doing a cross reference yields nothing but the 3 mov instructions. Can anyone tell me how to use these? How do you set up an input to use these bits? Thanks...
Status codes
- Thread starter bb1fit
- Start date
widelto
Member
They are a good help on HMI.
Without knowing anything about your system, I would ~GUESS~ that the status code is being used by an HMI to indicate the motor status. Like when StatusCode = 0, the motor/machine is Gray (or whatever your "OFF" Color is), =1 is Green, =2 is Red, possibly flashing.
Similar Topics
Hello everyone !
Is there a list for status information codes in diagnostic viewer? I am getting s908 remote I/O Failure with status information...
Hi
I have a ifix 5.5 application where the operator opens a valve by clicking on a screen object. I can trace from object to data base that it is...
Hi all.
I have 1793-IE4 (4)analog inputs modules in a 1794-ADN IOFlex DeviceNet Rack.
I cannot find if I can I have access to individual channel...
I've got a Powerflex 700 that doesn't like to get going in the mornings. This motor will run anywhere from 30 seconds to 5 minutes before it just...
Not a PLC question but I need expert help on this.
My FactoryTalk stopped communicating with the server its hosted on. I had an error stating...