Omron I/O units
- Thread starter yahmsn
- Start date
gtsuport
Member
yahmsn,
Welcome to the forum.
Both of those modules will use two consecutive I/O channels.
If you look at the I/O Table in the Project workspace on the left side of the CX-Programmer screen, it will show you the starting I/O channel for the module.
I hope this will help.
Welcome to the forum.
Both of those modules will use two consecutive I/O channels.
If you look at the I/O Table in the Project workspace on the left side of the CX-Programmer screen, it will show you the starting I/O channel for the module.
I hope this will help.
thank you
Similar Topics
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Hi all,
i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info.
my unit has an ip address of...
Hi all,
Currently having trouble getting a speed reference to write over modbus to an Omron M1...
I can successfully write a run command and...
Hi There,
I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...