Hello PLCs.net!
I have a kinetix 5500 drive connected to a gantry, I was wondering if there is a way to do active homing using a PLC tag?
At this moment, the AOP asked me to just go into the digital inputs tab and reassign one of the inputs as a homing input, currently the digital inputs 1&2 are used for positive and negative overtravel, so no spares.
Has anyone done homing through a PLC tag?
Regards,
-PreLC
I have a kinetix 5500 drive connected to a gantry, I was wondering if there is a way to do active homing using a PLC tag?
At this moment, the AOP asked me to just go into the digital inputs tab and reassign one of the inputs as a homing input, currently the digital inputs 1&2 are used for positive and negative overtravel, so no spares.
Has anyone done homing through a PLC tag?
Regards,
-PreLC