raj
Guest
R
Dear Sir,
One of my customer has Morey make milling machine from canada.
It has AB SLC 5/02 processor with three nos. of 1746-HS module (for X, Y, Z axis). Servo drive/motor are from Indramat.
One of the module (1746-HS) LOAD led is blinking. When i refered to the troubleshooting sheet it says that"AMP parameters are not loaded". But this machine has been running for a while and why does this message appear.
Also i donot have the full manual. I tried to search for some information about this 1746-HS module in AB manuals website and also AB Knowledge base.
TO my surprise i could only find information about 1746-HSRV module and could not find a manual for 1746-HS module. Is this module being replaced by HSRV module.
How can i program or load these AMP parameters. I understand that 1746-HS module uses MML or GML programing software to program the module and only HSRV module can be programmed with RSLogix 500.
I thought that i should replace HS module with HSRV module. But where can i find the AMP parameters for this module.
I uploaded the program from SLC processor but i donot find any info about HS module in that except I/O configuration.
How should i proceed now.
1. Replace HS with HSRV
2. Or load AMP parameters into HS. With what software and is that software still available?
Many thanks
One of my customer has Morey make milling machine from canada.
It has AB SLC 5/02 processor with three nos. of 1746-HS module (for X, Y, Z axis). Servo drive/motor are from Indramat.
One of the module (1746-HS) LOAD led is blinking. When i refered to the troubleshooting sheet it says that"AMP parameters are not loaded". But this machine has been running for a while and why does this message appear.
Also i donot have the full manual. I tried to search for some information about this 1746-HS module in AB manuals website and also AB Knowledge base.
TO my surprise i could only find information about 1746-HSRV module and could not find a manual for 1746-HS module. Is this module being replaced by HSRV module.
How can i program or load these AMP parameters. I understand that 1746-HS module uses MML or GML programing software to program the module and only HSRV module can be programmed with RSLogix 500.
I thought that i should replace HS module with HSRV module. But where can i find the AMP parameters for this module.
I uploaded the program from SLC processor but i donot find any info about HS module in that except I/O configuration.
How should i proceed now.
1. Replace HS with HSRV
2. Or load AMP parameters into HS. With what software and is that software still available?
Many thanks